Honeywell Voyager 1400g Series User Manual page 193

• You need to program a suffix. Programming a suffix enables the scanner
to output the bar code data plus the key you need (such as "CR") to enter
the data into your application. Refer to
on page 4-1 for further information.
Does the scanner read the bar code incorrectly?
If the scanner reads a bar code, but the data is not displayed correctly on
the host screen:
• The scanner may not be programmed for the appropriate terminal
interface.
For example, you scan "12345" and the host displays "@es%."
Reprogram the scanner with the correct Plug and Play bar code. See
Programming the Interface
• The scanner may not be programmed to output your bar code data
properly.
For example, you scan "12345" and the host displays "A12345B."
Reprogram the scanner with the proper symbology selections. See
Chapter 6.
The scanner won't read your bar code at all.
• Scan the sample bar codes in the back of this manual. If the scanner
reads the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see
If the scanner still can't read the sample bar codes, scan
(page 6-2).
If you aren't sure what programming options have been set in the scanner,
or if you want the factory default settings restored, refer to
Custom Defaults
beginning on page 2-1.
on page 1-7.
Prefix/Suffix Overview
Chapter
All Symbologies
Resetting the
beginning
6).
11 - 3