Mastercare Gen II Entree Bath Operation Manual
Hide thumbs
Also See for Gen II Entree Bath:
- Maintenance manual (17 pages) ,
- Operation manual (16 pages)
Subscribe to Our Youtube Channel
Related Manuals for Mastercare Gen II Entree Bath
Summary of Contents for Mastercare Gen II Entree Bath
- Page 1 Page 1 of 12 Gen II Entree Bath All Models Operations Manual Important Safety Instructions Read & Follow All Instructions Thoroughly 08-29-13...
- Page 2 Page 2 of 12 Operation Instructions IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS THROUGHLY The WARNING symbol identifies important safety messages. Failure to obey a safety warning may result in injury to you or to others CAUTION: The caution heading identifies important maintenance and operation information. Failure to obey a caution warning may result in damage to the Entree Bath and may void the warranty.
- Page 3 Page 3 of 12 General: Before operating the Entree Bath, familiarize yourself with See Attached the key features of the tub highlighted in the drawings Components Drawings supplied with these instructions (DVD provided). Page 7-10 (SM) Turn On The BathAire (SM) (SM) Turn on BathAire...
- Page 4 Fill tub 2-4” below bottom of overflow or 1” below door seal, this allows for resident movement and BathAire action. Add a minimum of ¼ oz of MasterCare’s Bath Oil to the water from the Dispensing bottle. The temperature of the bath water must never exceed 110 F.
- Page 5 MasterCare’s specially formulated Shampoo and Body Wash. Bathe or assist the individual with their hygiene needs. To rinse, lift the shower wand from its holder, located on the tub deck, and then direct the nozzle towards the open water in the tub.
-
Page 6: Cleaning Procedures
Fill to the bottom of the jet in the foot well with one (1) gallon of water. Using MasterCare's specially formulated Disinfectant cleaner dispense 2 oz (16 pumps) into the foot well water. Using the special long handled tub brush, scrub away any remaining organic materials sticking to the inside tub surfaces and seal area. -
Page 7: Other Considerations
Page 7 of 12 A) Never leave individual unattended during the entire bathing procedure. B) individuals must assessed, before using the system to determine if they will require the assistance of two staff members to transfer in to and out of the bath or if they are suitable for this procedure. - Page 8 Variable Speed System Control Basic Operation: Wave On/Off Button Button BathAire ThermAire Wave On/Off MasterCare Less Air/Heat More Air/Heat Button Button (SM) (SM) 1. BathAire on/off button: The BathAire can be turned on or off by pressing the on/off button. Press...
- Page 9 Page 9 of 12 Entree Bath Models MB-68-AV and MB-68-AV (XL) Door, Drain, BathAire and Control Panel: 1. Drain Open/Close Handle: To Close drain rotate drain handle counter clockwise to full close. To Open rotate drain handle clockwise Close to a full open position. CAUTION: Door will not open unless the drain is fully open.
- Page 10 GFCI Access Pan el All MasterCare bathing systems are equipped with onboard GFCI’s making them easy to access for your convenience. In the event a power surge trips the GFCI It can be accessed and reset using the following procedures: 1.
- Page 11 Per manufacturer recommendations it is NOT advised to use conditioners on the pads and straps. Disinfect the pads and straps with MasterCare Disinfectant according to the label and thoroughly rinse with water. Rotating the pads on a daily basis will help prolong the life of the pads.
- Page 12 Page 12 of 12 Entree Bath Training Check List: After Reviewing The Operation And Safety Instructions In This Manual The Entree Bath Can Be Operated And All Components Can Be Identified. OPERATION: Turn On BathAire Control Move Individual In To The Entree Bath Secure individual Close Tub Door With Push Buttons Close Drain With Open/Close Lever...
Need help?
Do you have a question about the Gen II Entree Bath and is the answer not in the manual?
Questions and answers