Bosch DWW063462 Operating And Installation Manual page 8

Exhaust Hood Cleaning and Maintenance
Disconnect the equipment from the power
source.
■ When filters are being replaced and
cleaned (see Chapter "Filters and their
Maintenance"), clean accessible exhaust
hood parts to prevent ignition and keep the
tool in optimal conditions.
■ For equipment cleaning use warm water
and detergent.
If here are stubborn stains (old spots) use
detergent for glass.
■ Do not rub dirty places, soak them in
water.
■ Do not use abrasive metallic sponges,
which can damage the surface of the
exhaust hood.
■ Warning: Do not use alcohol for cleaning
of plastic surfaces, as dark spots may
appear.
Attention! Ventilate the kitchen well and do
not leave open fire.
The cleaning of the remote control shall
be performed with a humid soft wipe (with
non concentrated detergent).
Do not use polishing means for stainless
steel.
Stainless steel surfaces:
■ Use non concentrated non abrasive deter-
gent for stainless steel.
■ Wipe the surface in the direction of po-
lishing.
Do not use for steel surface cleaning
any of the following materials:
Metallic sponges, means with content of
sand, soda, acid or chlorine!
8
Installation Instructions
Aluminium and plastic surfaces:
■ Use a soft wipe for glass, it does not leave
■ Do not use dry wipes.
■ Use non-concentrated detergent for
■ Do not use abrasive detergents.
fibres, or use a microfibre sponge.
windows. Do not use aggressive, acid or
corrosive means.