Bosch DWW063462 Operating And Installation Manual page 13

Connection to the Power Source
The electric line voltage shall comply with the
voltage, indicated in the nameplate, which
you can find inside of the exhaust hood. If the
exhaust hood is supplied with a plug, connect
it to the connector assembly in accordance with
the valid regulations, the connector assembly
shall be located in an easily accessible place.
If the plug is not provided (direct connection), or
the connector assembly is located in a difficult
accessible place
- use the appropriate two-pole switch that
provides a full disconnecting from the line in
case of overvoltage category III, according to
the installation instructions.
Attention: before connecting the exhaust hood
to the line and checking if its functions properly
make sure that the power cable is connected
correctly.
.
13