Disable The Dhcp Server Feature In The Router - NETGEAR Nighthawk RAX80 User Manual

3. Select ADVANCED > Setup > LAN Setup. The LAN Setup page displays.
4. Make sure that the Use Router as DHCP Server check box is selected.
5. Specify the range of IP addresses that the router assigns:
a. In the Starting IP Address field, type the lowest number in the range. This IP address
must be in the same subnet as the router.
b. In the Ending IP Address field, type the number at the end of the range of IP addresses.
This IP address must be in the same subnet as the router.
6. Click the Apply button.
Your settings are saved.
The router delivers the following parameters to any LAN device that requests DHCP:
• An IP address from the range that you define
• Subnet mask
• Gateway IP address (the router's LAN IP address)
• DNS server IP address (the router's LAN IP address)

Disable the DHCP server feature in the router

By default, the router acts as a DHCP server. The router assigns IP, DNS server, and default
gateway addresses to all computers connected to the LAN. The assigned default gateway address
is the LAN address of the router.
You can use another device on your network as the DHCP server or specify the network settings
of all your computers.
To disable the DHCP server feature in the router:
1. Launch a web browser from a computer or mobile device that is connected to the router
network.
2. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time that you
logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
3. Select ADVANCED > Setup > LAN Setup. The LAN Setup page displays.
Manage Network Settings
Nighthawk AX8 8-Stream AX6000 WiFi Router
54 User Manual