Denon AVC-X4700H Owner's Manual page 272

Contents Connections
Initializing registered preset codes
1
Press and hold down MAIN and OPTION until the DEV.,
TV and AVR indicators on the remote are flashing
green, then release.
Specifying the operating zone with the
remote control
To prevent accidental misuse, you can set the zone for which the remote
control unit is used.
1
Press and hold down either MAIN, Z2 or Z3 and SETUP
at the same time until the DEV., TV and AVR indicators
flash green.
MAIN:
Z2:
Z3
(Default):
Front panel Display
Playback
When only using MAIN ZONE
When using MAIN ZONE and ZONE2
When using MAIN ZONE, ZONE2 and
ZONE3
Rear panel
Settings
Resetting the remote control unit
All the settings are restored to their defaults.
1
Press and hold down DEVICE MENU until the DEV., TV
and AVR indicators on the remote are flashing green,
then release.
2
Press 9, 8 and 1, in that order.
The DEV., TV and AVR indicators flash twice.
All the settings are restored to their defaults.
272
Remote
Tips Appendix
Index