0 If the input for ZONE2 is set to a specific source (like CBL/SAT), only analog signal or 2-channel PCM signal input (from HDMI connectors or digital connectors (OPTICAL/

COAXIAL)) can be listened to from ZONE2. To playback HDMI signal other than 2-channel PCM in ZONE2, set "HDMI Audio" to "PCM". (v p. 255)

2-channel PCM signals are output from a device connected to the input source selected for ZONE2 and can be played back in ZONE2. In this case, the MAIN ZONE audio

will also be converted to 2-channel PCM signals if the MAIN ZONE and ZONE2 are set to the same input source. However, depending on the playback device, the playback

signal may not be converted to PCM even if this setting is configured.

0 The analog audio signal and the 2-channel PCM signal input from digital connectors (OPTICAL/COAXIAL) can be played back in ZONE3.

0 When "Component Video Out" in the menu is set to "ZONE2", the component video output connector outputs the ZONE2 video. (v p. 199)

0 The menu screen is not output in ZONE2 and ZONE3.

Front panel

Display

Playback

Settings

164

Rear panel

Tips

Remote