Notices; Fcc Radiation Exposure Statement; Radio Frequency Interference Requirements; Interference Statement - Fortinet AP400 Series Installation Manual

Notices

The unit is intended for installation in Environment A as defined in IEEE 802.3.af. All intercon-
nected equipment must be contained within the same building, including the interconnected
equipment's associated LAN connection.
Suitable for use in environmental air space in accordance with Section 300-22(c) of the
National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electri-
cal Code, Part 1, C22.1.

FCC Radiation Exposure Statement

The radiated output power of the Fortinet devices is well below the FCC radio frequency exposure lim-
its. However, the Access Point should be used in such a manner that the potential for human contact
during normal operation is minimized. When installing and operating these devices, keep a minimum
distance of 20 cm (8 inches) between the antennas and any persons/users in the vicinity.

Radio Frequency Interference Requirements

The Interference Statement applies to the following APs:
•
AP150
•
OAP180
•
AP1000
•
AP300
•
AP400
Fortinet Access Points
All devices except the OAP180 are indoor devices. The FCC requires indoor use for the frequency
range 5.15 GHz to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Sat-
ellite systems.
High-power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands.
These radar stations can cause interference with or damage to these devices, or both.

Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
USA 75