Using The Clock, Alarm And Sleep Timer Features - Grundig G4000A Operation Manual

8

USING THE CLOCK, ALARM AND SLEEP TIMER FEATURES

H O W T O S E T T H E C L O C K
This can be done with the radio on or off. The
G4000A's clock is a 24 hour clock only, e.g. 6'oclock
in the morning will read as 6:00; 6 o'clock in the
evening will read as 18:00. There are two clocks,
TIME I and TIME II. Select one or the other by pressing
the TIME 1/2 button. TIME I or TIME II shows in
the display at top center. Set the time using the
examples below.
EXAMPLE 1: If it is 06:00 hours press 6 . 0 0,
then immediately press the TIME 1/2 button.
EXAMPLE 2: If it is 15:32 hours press 1 5 . 3 2,
then immediately press the TIME 1/2 button.
H O W T O S E T T H E A L A R M C L O C K
The alarm time is shown in the upper left corner of
the display, under "ON TIME," when the radio is off.
To set the alarm to activate at 6:30:
1. Press 6 . 3 0 (be sure to include the decimal point)
2. Immediately press and release the ON TIME button.
3. Select the alarm mode using the AUTO button.
14
H O W T O C O N T R O L T H E A L A R M
C L O C K
• Press the AUTO button several times while
looking at the upper left corner of the display.
• The "musical note" symbol wakes you to the
radio playing the last station it was set to.
• The "bell" symbol wakes you to a beeper sound.
• When both symbols disappear and -:— appears,
THE ALARM IS DEACTIVATED.
H O W T O U S E T H E A L A R M
C L O C K ' S S N O O Z E F E AT U R E
( b u t t o n o n t o p o f r a d i o )
Once the alarm has activated, you can get 5 minutes
more sleep by briefly pressing the SNOOZE button.
You can repeat this as many times as you like.
By pressing the SNOOZE button for more than
2 seconds, you can completely shut off the alarm.
USING THE CLOCK, ALARM AND SLEEP TIMER FEATURES
H O W T O S E T T H E S L E E P T I M E R
Press the SLEEP button over and over. Each press
changes the amount of time the radio will play before
shutting off automatically, 60 through 0
minutes.
H O W T O U S E T H E D I A L L I G H T
( b u t t o n o n t o p o f r a d i o )
The LIGHT button causes the display to be illuminated.
After 10 seconds, or when the LIGHT button is
pressed again, the light will go out.
G 4 0 0 0 A O P E R A T I O N M A N U A L
continued
15