Attach The Warning Labels - Craftsman CMXEOCG231 Owner's Manual

CONNECT DOOR ARM TO TROLLEY (CONTINUED)
ALL ONE-PIECE DOORS
IMPORTANT: The groove on the straight door arm MUST face away from the curved
door arm (Figure 5).
1. Close the door. Disconnect the trolley by pulling the emergency release
handle.
2. Fasten the straight door arm and the curved door arm together to the
longest possible length (with a 2 or 3 hole overlap) using the bolts, nuts,
and lock washers.
3. Attach the straight door arm to the door bracket using the 5/16"x1-1/4"
clevis pin. Secure with the ring fastener.
4. Attach the curved door arm to the trolley using the 5/16"x1" clevis pin.
Secure with the ring fastener.
5. Pull the emergency release handle toward the garage door opener until
the trolley release arm is horizontal.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 Lock Washer 5/16"
Clevis Pin
5/16"x1" (Trolley)
INSTALLATION STEP 10

ATTACH THE WARNING LABELS

1. Attach the entrapment warning label on the wall near the door control with
tacks or staples.
2. Attach the manual release/safety reverse test label in a visible location on
the inside of the garage door.
Ring Fastener
Clevis Pin Hex Bolt
5/16"x1-1/4" (Door Bracket) 5/16"-18x7/8"
Figure 5
CORRECT
Straight
Door Arm
Curved
(Groove Door Arm
facing out)
Figure 6 One-Piece Door Without Track
Pulley
Inner Trolley
Rail Tab
Straight
Ring Fastener
Ring
Door
Nuts
Fastener
Arm
5/16"-18
Lock Washers
Door
5/16"
Bracket
Curved
Door Arm
Clevis Pin
5/16"x1-1/4"
Figure 7 One-Piece Door With Track
Ring Fastener
Nuts 5/16"-18
Ring Fastener
Lock Washers 5/16"
Clevis Pin
Hex Bolt 5/16"-18x7/8"
5/16"x1-1/4"
21
INCORRECT
Straight
Door Arm
Curved
Door
Arm
Outer Trolley
Clevis Pin
5/16"x1"
Hex Bolts
5/16"-18x7/8"
Emergency
Release
Handle
Clevis Pin
5/16"x1"