Advertisement
Introduction
Introduction
Product Description
The Market Forge Sterilmatic Sterilizer with Digital Controller (model STM-ED) is a compact, automatic, low cost steam
pressure sterilizer (autoclave).
The sterilizing cylinder is a 3/16" (4.8mm) thick wall, welded aluminum. The exterior is made of polished stainless steel.
Interior dimensions of 16" (406mm) diameter and 26" (660mm) long with a cubic content of 5,220 cubic
inches (0.085 cubic meters) and has a door opening of 13-1/2" (343mm) wide and 11" (279mm) high. The sterilizing
compartment has a pan capacity of:
•
(3) 12" x 20" x 2 ½" (305mm x 508mm x 64mm) or,
•
(2) 12" x 20" x 4" (305mm x 508mm x 102mm) or,
•
(1) 12" x 20" x 6" (305mm x 508mm x 152mm)
The sterilizer door is a self-sealing type that cannot be opened until the steam pressure is completely exhausted from the
chamber. The door is 12 gauge stainless steel and removable for cleaning without tools. The door gasket is one-piece
molded, also replaceable without tools or cement.
The sterilizing cycle is fully automatic with the time, temperature and venting controlled by the microprocessor based,
digital controller.
The sterilizing temperature can be set anywhere in a range from 225°F (107°C) and 250°F (121°C). There is an on-board
data logger/printer. The data logger records the time, temperature and pressure for each sterilization cycle. This data can
be stored for future printing or printed out following each cycle.
Operating Environmental Conditions
This unit is designed for commercial use and to be safe at least under the following conditions:
•
For indoor use only.
•
For use at altitudes up to 6500ft (2000m)
•
For use at temperatures from 41°F (5°C) to 104°F (40°C).
•
Maximum relative humidity 80% for temperatures up to 88°F (31°C) decreasing linearly to 50% relative humidity at
104°F (40°C).
•
Main supply voltage fluctuations not to exceed ±10% of nominal voltage.
•
Transient overvoltages according to Installation Categories II (in accordance with IEC 664).
•
Pollution Degree 2 (in accordance with IEC 664).
Service & Technical Information Contact
Your Sterilmatic Sterilizer has been developed to answer the need for a compact, automatic, low-cost steam pressure
sterilizer. The following instructions cover installation.
Should service be required, it is readily available by contacting our authorized service agency located nearest to you. The
name of your local service company can be obtained on our website, www.mfii.com.
6
PAGE
OF 24
This unit should be serviced by qualified service personnel only.
INSTALLATION & OPERATION MANUAL 14-0413 REV 0 (08/21)
Sterilmatic - Digital Electric Sterilizer
WARNING
- Quick Links:
- Operation
- Maintenance
Hide quick links:
Advertisement
