Market Forge Industries Sterilmatic Installation & Operation Manual

Digital electric sterilizer

Hide thumbs

Table Of Contents

Quick Links

Installation & Operation Manual

Sterilmatic - Digital Electric Sterilizer

Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury

or death. Read the installation, operating and maintenance instructions thoroughly before installing or

ANUAL 14-0413

EV 0 (08/21)

$21.00

STM-ED & STM-EDX

servicing this equipment.

CROWN FOOD SERVICE EQUIPMENT

70 Oakdale Road, Downsview (Toronto) Ontario, Canada, M3N 1V9

Telephone: 919-762-1000

STM-ED

WARNING

A Middleby Company

www.crownsteamgroup.com

STERILMATIC - DIGITAL ELECTRIC STERILIZER

IMPORTANT FOR FUTURE REFERENCE

Please complete this information and retain this

manual for the life of the equipment:

Model #: ___________________________

Serial #: ___________________________

Date Purchased: _____________________

ANUAL

ECTION

Table of Contents

Need help?

Do you have a question about the Sterilmatic and is the answer not in the manual?

Questions and answers

Summary of Contents for Market Forge Industries Sterilmatic

Page 1 Model #: ___________________________ Serial #: ___________________________ Date Purchased: _____________________ Installation & Operation Manual Sterilmatic - Digital Electric Sterilizer STM-ED & STM-EDX STM-ED WARNING Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death.
Page 2 Sterilmatic - Digital Electric Sterilizer Your Service Agency’s Address: Model Serial number Kettle installed by Installation checked by PAGE OF 24 INSTALLATION & OPERATION MANUAL 14-0413 REV 0 (08/21)
Page 3: Important Notes For Installation And Operation
Sterilmatic - Digital Electric Sterilizer Safety Precautions SAFETY PRECAUTIONS Before installing and operating this equipment, be sure everyone involved in its operation is fully trained and aware of precautions. Accidents and problems can be caused by failure to follow fundamental rules and precautions.
Page 4: Table Of Contents
Table of Contents Sterilmatic - Digital Electric Sterilizer RETAIN THIS MANUAL FOR FUTURE REFERENCE. Table of Contents Important Notes For Installation and Operation ..............3 Service Connections ......................5 Introduction ........................... 6 Installation ..........................8 Operation ..........................13 Maintenance ......................... 21 Warranty ..........................
Page 5: Service Connections
Sterilmatic - Digital Electric Sterilizer Service Connections Service Connections DIMENSIONS ARE IN INCHES [MM] DIMENSIONS ARE IN INCHES [MM] STEAM SHIELD 18.69 [475] 3 [76] STEAM SHIELD 21 [533] CHAMBER 9.34 [237] SEE NOTE 2 5.63 9 [230] 12 [305]...
Page 6: Introduction
Introduction Product Description The Market Forge Sterilmatic Sterilizer with Digital Controller (model STM-ED) is a compact, automatic, low cost steam pressure sterilizer (autoclave). The sterilizing cylinder is a 3/16” (4.8mm) thick wall, welded aluminum. The exterior is made of polished stainless steel.
Page 7 Sterilmatic - Digital Electric Sterilizer Introduction Intended Use - Sterilization Cycle This unit is intended to be operated intermittently. After a pre-heat cycle, the longest period of sterilization (heating) should be a maximum of 60 minutes. The digital timer allows up to 99 minutes, but it should be kept at no more than 60 minutes.
Page 8: Installation
Clearance from combustible and non-combustible construction should be a minimum of 4” in the back and 2” on the sides. If your Sterilmatic includes a water-cooled exhaust condenser, we recommend the use of the Sterilmatic stand, part number 95-6060. First, level unit in place, then adjust rear legs to pitch the unit forward 1/4” (6mm) to insure positive drainage of the cylinder.
Page 9 Baffle Installation To insure maximum drying of packs, a baffle is supplied with your Sterilmatic. Place perforated splash baffle in bottom of the sterilizing chamber. Install small baffle with no perforation at the rear of the upper tray support channel.
Page 10 Installation Sterilmatic - Digital Electric Sterilizer Optional Cold Water Condenser Item Part No. Description Quantity 95-2119 Steam condensing unit 95-2219 Thermostat Box Assembly 95-0086 Exhaust line 15-7057 Copper tubing 3/8 OD, 22.25” 10-1775 Rd. Hd. Mach. Screw, 1/4-20 10-2500 Lockwasher, 1/4...
Page 11 Sterilmatic - Digital Electric Sterilizer Installation Figure 3 Pan Supports and Baffles 1. Locate the mounting studs on the inside of the chamber. There are two rack mounting studs on each side. Figure 4 2. Taking one pan support and positioning rack so that the pan stop is facing the rear of the unit and the wires are facing toward the center of the unit.
Page 12 The open design lends itself to maximum sanitary conditions because of the ease with which periodic cleaning can be done. Though simple in design and appearance, the sterilmatic stand is the ideal arrangement for mounting in that it allows secondary air to circulate.
Page 13 Sterilmatic - Digital Electric Sterilizer Operation General Operating Instructions IMPORTANT Make sure the drain valve is closed. Fill bottom of the sterilizer chamber with approximately six quarts of water or just below ledge at bottom of door opening. (If water supply is known to be hard or corrosive, a source of treated water should be used.) DO NOT USE DISTILLED OR deionized WATER.
Page 14: Operation
Operation Sterilmatic - Digital Electric Sterilizer Sterilization Guide • PACKS (Linens, gloves, etc.): Use wire basket to facilitate drying. Be sure condensate baffles are in place. Place packs on edge and arrange load in chamber, so that only minimal resistant to passage of steam through the load will exist.
Page 15 Sterilmatic - Digital Electric Sterilizer Operation Digital Control Panel Figure 8 Before operating this unit, be sure to have read the Owner’s manual for proper setup, service connections and installation. In addition, the Owner’s manual will cover sterilization recommendations, daily cleaning procedures and parts lists.
Page 16 Operation Sterilmatic - Digital Electric Sterilizer Figure 9 Setup • Make sure the unit is connected to its electrical source. • Make sure the unit has recommended amount of water in its chamber. • Make sure the unit drain is closed. If a ventilation hood is required.
Page 17 Sterilmatic - Digital Electric Sterilizer Operation Figure 12 Manual Menu The Manual setup screen provides options to set desired Times, Temperatures and Slow or Fast vent. The values displaying on the opening screen are the default values. Setting Time, Temp & Vent 1.
Page 18 Operation Sterilmatic - Digital Electric Sterilizer Figure 14 Sterilizing Cycles 1. Pre-Heating Cycle: Once the manual or presents key is selected, the sterilizer is heating up to the sterilization temperature set point. While heating, the set point time is displayed and will not change, but the chamber’s temperature and pressure...
Page 19 Sterilmatic - Digital Electric Sterilizer Operation Figure 18 Printing/USB Data Logger By connecting the USB Flash Drive to the USB port located on the panel (Refer Figure: 8) (2), the operator will be able to retrieve the Time, Temperature and Pressure during all phases of the entire sterilization cycle in an excel file format.
Page 20 Operation Sterilmatic - Digital Electric Sterilizer Low Water Reset If the water inside the chamber is allowed to run dry it will trigger the Low Water Cut-off. At this point the unit will; • Shut down all three heating elements •...
Page 21: Maintenance
After washing thoroughly rinse with clean water. Dry cylinder* and leave door open overnight. The Sterilmatic cylinder is constructed of corrosion resistant Alclad aluminum alloy. The protective properties of this material afforded to the interior portion of the cylinder which is exposed to water may be destroyed by allowing a film to form.
Page 22: Warranty
Warranty Sterilmatic - Digital Electric Sterilizer Warranty Sterilizer (Autoclave) Warranty MODELS: STM-ED, STM-EDX* We warrant to the original purchaser that the sterilizers manufactured by Market Forge will be free from defects in material and factory workmanship if properly installed and operated under normal conditions. Within one year from date of original installation, or within 15 months from date of shipment from factory, whichever is sooner, we will repair or replace that part of any such machine that becomes defective at no cost to the customer.
Page 23 Sterilmatic - Digital Electric Sterilizer Notes INSTALLATION & OPERATION MANUAL 14-00413 REV 0 (08/21) PAGE OF 24...
Page 24 Sterilmatic - Digital Electric Sterilizer STM-ED & STM-EDX Sterilmatic Digital Electric Sterilizer A product with the Market Forge name incorporates the best in durability and low maintenance. We all recognize, however, that replacement parts and occasional professional service may be necessary to extend the useful life of this appliance.

This manual is also suitable for:

Stm-ed Stm-edx