Table of Contents
Advertisement
ET42202XM-S-PD
L2+ Managed 20-port 100/1000Base-FX SFP + 4-port 10/100/1000Base-TX or 100/1000Base-FX SFP
Combo + 4-port 1000/10GBase-FX SFP Optical Ethernet Switch, AC + DC power inputs
source.
Step1.Insert the DC cable plug directly into the DC terminal block located at the front of the switch.
Step2.Plug the other end of the cable into an external DC power source.
Step3.Check the front-panel LEDs as the device is powered on to be sure the POWER LED is lit. If not,
check that the power cable is correctly plugged in.
AC Power Connecting
You can plug or remove AC power cord through the AC socket from AC power source.
Step1. Insert the power cable plug directly into the AC Socket located at the back of the switch.
Step2. Plug the other end of the cable into a grounded, 3-Pin, AC power source.
Step3. Check the front-panel LEDs as the device is powered on to be sure the POWER LED is lit. If not,
check that the power cable is correctly plugged in.
Ethernet Interface Connecting (RJ45 Ethernet)
To ensure proper operation when installing the switch into a network, make sure that the current
cables are suitable for 100BASE-TX or 1000BASE-T operation. Check the following criteria against
the current installation of your network:
Cable type: Unshielded twisted pair (UTP) or shielded twisted pair (STP) cable with RJ-45
◆
connectors; Category 5 or Category 5e with maximum length of 100 meters is recommend
100BASE-TX, and Category 5e or 6 with maximum length of 100 meters is recommend for
W
:
For International use, you may need to change the AC
ARNING
line cord. You must use a line cord set that has been approved for
the socket type in your country.
5
Advertisement
Table of Contents
