Labels Supplied With The Accessories Bag; Before The Installation - Zanussi ZGG66424 User Manual

Problem
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
IF YOU CANNOT FIND A SOLUTION...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre. Give the data from the rating plate. Make
sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not
be free of charge, also during the warranty period.
A
MOD.
PROD.NO.
SER.NO
DATA
A. Stick it on Guarantee Card and send this part
(if applicable).
B. Stick it on Guarantee Card and keep this part
(if applicable).
INSTALLATION
WARNING! Refer to Safety chapters.
10
Possible cause
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
The instructions about the Service Centre and
conditions of guarantee are in the guarantee
booklet.
LABELS SUPPLIED WITH THE ACCESSORIES
BAG
Stick the adhesive labels as indicated below:
C
MOD.
PROD.NO.
SER.NO.
0049
C. Stick it on instruction booklet.

BEFORE THE INSTALLATION

Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Remedy
After lightning the flame, keep
the knob pushed for equal or
less than 10 seconds.
Make sure that the injector is
not blocked and the burner
crown is clean.
TYPE
IP20