ControlOMatic POOLWARDEN PW-Plus Installation Manual page 4

IMPORTANT WARNING AND SAFETY INSTRUCTIONS
8 WARNING
service including the main AC power and any other AC sources that
may be connected to the AUX relays. Never apply power when
PoolWarden service door is unlocked or in the open position. Only
qualified and licensed technicians should perform any service or
repair.
9 WARNING
longer than 3 meters.
10 WARNING
mount PoolWarden above any other electrical equipment.
11 WARNING
to the public.
12 WARNING
12.1 Never mix sodium hypochlorite and muratic acid!
12.2 When mixing acid and water, always add acid to the water,
never add water to the acid.
13 CAUTION
BEFORE EACH USE OF THE POOL/SPA
14 CAUTION
CLASS A GROUND FAULT CIRCUIT INTERRUPTER
15 Do not dispose in trash. Please visit
for recycling information.
1 ATTENTION: TOUJOURS VÉRIFIER L'EFFICACITÉ DU
DISJONCTEUR DIFFÉRENTIEL AVANT D'UTILISER LE BAIN
2 ATTENTION: LIRE LA NOTICE TECHNIQUE
3 AVERTISSEMENT: DÉCONNECTER DU CIRCUIT D'ALIMENTATION
ÉLECTRIQUE AVANT L'ENTRETIEN
4 ATTENTION: CONNECTER UNIQUEMENT À UN CIRCUIT PROTÉGÉ
PAR UN DISJONCTEUR DIFFÉRENTIEL DE CLASSE A
PoolWarden Manual
– Disconnect all power to PoolWarden prior to any
– Do not install load bearing leads and/or sensor cables
– Always mount PoolWarden in safe and dry area. Never
– Install PoolWarden in a location that is not accessible
– Pool and Spa Chemical Safety
– TEST THE GROUND FAULT CIRCUIT INTERRUPTER
– CONNECT ONLY TO A CIRCUIT PROTECTED BY A
• www.poolwardentraining.com
www.controlomatic.com
• 530-205-4520 • 4