Unpacking Instructions - Fanimation WINDPOINTE FP7500 Series Manual

This manual is designed to make it as easy as possible for you to assemble,
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel you
do not have enough wiring knowledge or experience, have
your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts supplied with
this product and/or any accessories designated specifically for use with this product by Fanimation. Substitution of parts
or accessories not designated for use with this product by Fanimation could result in personal injury or property damage.
Contact your retail store for missing or damaged parts.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Downrod/Hanger Ball Assembly (1)
Hanger Bracket
Assembly (1)
– Downrod (1)
– Hanger Ball (1)
– Set Screw (1)
Hardware Bags
1/4"-20
Screws with Lockwashers
(11)
Knurled Knobs
Threaded Rods
(2)
install, operate and maintain your ceiling fan
• One stepladder
• One wire stripper

Unpacking Instructions

– Hairpin Clip (1)
– Clevis Pin (1)
– Pin (1)
3/16"-24 3/16"-24
Carriage Head Nuts Washer Head Screws
(11) (11)
5/32˝
5/32˝
Lockwashers
(2)
(2)
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing, contact your local retailer.
WARNING
Ceiling Canopy (1)
Motor Assembly (1)
Blade Holder
Blade Holder Set (1)
Cover Set (1)
Wire Connectors
(4)
Fan Fob Pull Chain Coupler
(1) (1)
4
Materials
nstalled ire ength
p to ft
ft
Motor Coupling
Cover Assembly (1)
Blade Set (Not Included)
Safety Cable Kit
Safety Cable
(1)
Cable Clamp
(1)
ire i e
Switch Cup Housing/
Adapter Assembly (1)
Flat Washer,
Stainless Steel
(1)
Lag Bolt
(1)