Table of Contents
Advertisement
Quick Links
ODU MINI-SNAP Series L, K, B
Assembly Unsealed Plugs, Series L (IP 50)
Housing
Insert with
solder capacity
1. Slide back nut and cable collet (and possibly cable bend relief ) over the cable.
2. Strip cable and wire
corresponding the table
(see page 18).
3. Pre-tinning of strands.
4. Solder each wire (A) to the
corresponding contact.
Page 2
Half-shells
Cable collet
A
010.014.000.000.000
Assembly Instructions
Back nut (style 1)
Back nut for
Cable bend relief
cable bend relief
(style 2)
www.odu.de
Advertisement
Table of Contents
Related Manuals for ODU MINI-SNAP L Series
Summary of Contents for ODU MINI-SNAP L Series
- Page 1 010.014.000.000.000 ODU MINI-SNAP Series L, K, B Assembly Instructions Assembly Unsealed Plugs, Series L (IP 50) Housing Half-shells Back nut (style 1) Insert with Cable collet Back nut for Cable bend relief solder capacity cable bend relief (style 2) 1. Slide back nut and cable collet (and possibly cable bend relief ) over the cable.
- Page 2 010.014.000.000.000 ODU MINI-SNAP Series L, K, B Assembly Instructions 5. Bend cable shield outwards, assemble half-shells. 6. Slide the cable collet against the half-shells and clamp the shield (B) between it. 7. Now you can put the assembled cable considering the guidings (C) into the connector housing.
Need help?
Do you have a question about the MINI-SNAP L Series and is the answer not in the manual?
Questions and answers