Table of Contents
Advertisement
Seat Assembly
Insert the seat stem into the frame (figure 4), you can use grease to help assembly. Insert at
least to the minimal indication on the seat stem using rotary movements.
Pull the quick-release lever free and insert the seat-post to the minimal insertion marker
indicated on the seat-post. Tighten the quick-release clamp and then fold the lever to closed
position. Minimal torque specifications are 19.5Nm.
Figure 4
Torque Specifications
The handlebar is fitted to a stem. The height of some stems can be adjusted. If you must
dismantle the handlebar or turn it to transport the bicycle, please make sure that you
correctly reassemble and centre the handlebars; check the position by placing your hands
on the grips to find the best position. Make sure all bolts are correctly tightened. Once
handlebar and stem are assembled, make sure that the brake and derailleur sheaths are
free.
Recommended torque specification: 13-14Nm.
Recommended torque specification for the rear rack is 16Nm.
You can adjust the angle of the stem by adjusting the bolt located under the stem using an
Allen key. Once you have found the desired angle, tighten the stem to the headset.
Recommended torque specifications are 18-20Nm.
If you remove nut fitted wheels, make sure that when you replace them you respect a
minimal recommended torque specification of 30Nm for the rear wheel and 25Nm for the
front wheel.
Advertisement
Table of Contents
