Table of Contents
Advertisement
Front Derailleur Movement:
1.
Adjusting the inner stop (figure 6).
By turning the outer screw of the front derailer in direction A, the derailer range moves
towards to the smallest chain ring; by turning it in direction B, it moves away from the large
chain ring. Then adjust so that the clearance between the chain guide inner plate and the
chain is between 0 and 0.5 mm.
2.
Adjusting the outer stop (figure 7).
By turning the inner screw of the front derailer in direction A, the derailer range moves away
from the smallest chain ring; by turning it in direction B, it moves towards the large chain
ring. Then adjust so that the clearance between the chain guide outer plate and the chain is
0 to 0.5mm.
Chain guide inner plate
Chain
Rear Derailleur Travel:
Adjusting the cable tension creates a link between a position on the gear lever and a
position in the gear system. Unscrew or tighten the cable tension screw at the lever or at the
rear of the derailer so that each lever position corresponds to a cog (figure 8):
•
If the chain does not move down every time you shift the lever: Loosen the cable by
turning the cable tension adjusting screw clockwise.
•
If the chain does not move up every time you shift the lever. Tighten the cable up by
turning the cable tension adjusting screw anticlockwise.
Figure 6
Figure 8
Chain guide outer plate
Figure 7
Chain
Advertisement
Table of Contents
