Table of Contents
Advertisement
All programmed functions are accessed by entering * # * <FUNCTION NUMBER>.
For example to set the IP address enter "* # * 1", a confirming tone will be heard from
the controller and the new address can then be entered.
Functions
Two programming functions are provided with the P2.net:
Set P2.net IP Address (Required)
Set Server IP Address Filter (Optional)
The only required setting is the IP address. Note that if the P2.net is connected to the
same subnet as the Server PC; then the P2.net IP address can be set from the
software. The keyboard is primarily used to set the address when the P2.net is on the
other side of a router on a different subnet.
In addition, the P2.net communications with the server PC can be locked down by
specifying the server address.
Set P2.net IP Address
The P2.net IP address is the address used by Doors Express to communicate with the
P2.net and attached controllers. This needs to be a fixed IP address. If connected to
the end users LAN, a suitable address must be provided by the network supervisor
from the fixed IP address range. The factory set value for this is 192.6.32.200.
To set the IP address to: 192.168.0.27 enter the following sequence.
Set Server IP Address Filter (Optional)
This function is entirely optional and not required for the operation of the P2.net with
Doors Express. Its purpose is to filter which IP address that the P2.net will accept data
from. This, in effect "locks" the P2.net to work with one server only, preventing any
possible hacking. The down side to this is that if the servers IP address changes this
value will have to be updated in the P2.net. The factory set value for this is 0.0.0.0
(Disabled)
To set the IP address to: 192.168.0.5 enter the following sequence.
Controller / Door Name Table
On the following page is a table for the door controller ID label to be located during
installation. Simply attach the sticker to the table and enter a brief description of the
location of the door controller. This list can then be checked during setup to confirm
that all doors are on the system and labelled correctly.
* # * 1 192 * 168 * 0 * 27 #
* # * 2 192 * 168 * 0 * 5 #
17
Advertisement
Table of Contents
