P2.net
P2.net provides a 10 / 100 Base T Ethernet connection via an RJ45 socket. This
makes the P2 system or parts of it "IP Addressable". The P2.net can be used by itself
or in conjunction with the P2 USB interface and or additional P2.net controllers. The
only restriction is that the total number of door controllers is 16 or less.
P2.net controllers may be located on the same local area network or on a remote wide
area network on different subnet.
Status (Green): Lights when connected to Doors
Express and blinks data is received.
Flashes twice every two seconds when no connection
to Doors Express.
Status (Red): Flashes alternately with the green
status when IP settings are changed.
Link/Data (Green): lights when "live" Ethernet cable
is plugged into the Module. This LED will blink when
data is received from the Doors Express Server.
100BaseT (Red): lights when the P2.net is linked to a
hub or switch at 100Mb/S. The LED is off when the
link is 10Mb/S
Programming
Keyboard
The P2.net programming keyboard is located under the lid of the controller. Remove
the two screws and lid to access the keyboard.
P2.net Controller
16