Table of Contents
Advertisement
Description
The P2 USB Interface allows data to be transferred from a host PC to the P2
controllers.
Box Contents
1 x P2 USB Interface
1 x UK standard surface mount single back box
1 x 3 metre USB lead
2 x screws
Mounting
The USB Interface cannot be fitted on a flush mounted back box and should be
mounted on the special surface mount back box which is provided.
Connections
The USB cable is connected from the host PC using the USB socket at the bottom of
the P2 USB Interface (before connecting the device for the first time it is important to
start Doors Express first which will complete the driver installation).
The P2 USB Interface is powered through a USB cable from the PC and does not
require a separate power supply. The green flashing LED on the PCB on the rear of
the P2 USB Interface gives an indication as to whether the board is receiving power.
The P2 USB Interface should be connected to a P2 Controller by linking the Network A
and B terminal block on the P2 USB Interface to the Network A and B terminal block on
the P2 Controller.
P2 USB Interface
Figure 9
12
Advertisement
Table of Contents
