Assembly And Operation - Redback E435C Operation Manual

ASSEMBLY AND
OPERATION
Assembling the Blower
Tube
GENERAL SAFETY
WARNING #2
The blower tube can be installed on the
blower without using any tools.
1. Slide the blower tube over the outlet
on the blower housing.
2. Rotate the tube clockwise and match
with the outlet fully.
.
Installing and Removing the
Battery Pack
1. To insert the battery, slide it into the
battery cradle on the blower, aligning
the ribs in the cradle with the slots in the
battery until it latches into place. Check
speed setting is indicated by the LED
lights above the speed buttons.
3. To decrease speed, press the
decrease speed button (9). With each
press of this button the blower will move
from 'Turbo' to High Speed, then to
12
that the battery is securely locked into
place.
2. To remove the battery, press and
hold the latch on the rear of the battery
pack and slide the battery away from the
blower.
Starting/Stopping the
Blower
1. To start the blower, press the start
button first then, press speed increase
button (7). The blower will start to run in
Low Speed.
2. Press the Speed Increase button
again for Medium Speed, High Speed,
and 'Turbo' mode (100% power). The
Medium then to Low Speed.
4. Press the stop button (10) to stop the
blower.
5. To conserve battery life, the blower
will only run in 'Turbo' mode for 30
seconds before automatically switching