Redback E435C Operation Manual page 4

when barefoot or wearing open sandals.
Avoid wearing clothing that is loose
fitting or that has
hanging cords or ties.
3. Do not wear loose clothing or jewelry
that can be drawn into the air inlet. Keep
long hair away from the air inlets.
4. Operate the machine in a
recommended position and only on a
stable level surface.
5. Do not operate the machine on a
paved or gravel surface where ejected
material could cause injury.
6. Before using, always visually inspect
to see that bolts and other fasteners are
secure, the housing is undamaged, and
that guards and screens are in place.
Replace worn or damaged components
in sets to preserve balance. Replace
torn or unreadable labels.
7. Never operate the machine while
people, especially children, or pets are
nearby.
Operation
1. Before starting the machine, ensure
that the feeding chamber is empty.
2. Keep your face and body away from
the feed intake opening.
3. Do not allow hands, any other parts of
the body, or clothing inside the feeding
chamber, discharge chute, or near any
moving part.
3
4. Keep proper balance and footing at
all times. Do not overreach. Never stand
at a higher level than the base of the
machine when feeding material into it.
5. Always stand clear of the discharge
zone when operating this machine.
6. When feeding material into the
machine, be extremely careful that
pieces of metal, rocks, bottles, cans or
other foreign objects are not included.
7. If the machine should start making
any unusual noise or vibration,
immediately switch it off and allow the
machine to stop. Remove the battery
pack from machine and take the
following steps before restarting and
operating the machine:
a) Inspect for damage.
b) Replace or repair any damaged parts.
c) Check for and tighten any loose parts.
8. Do not allow processed material to
build up in the discharge zone; this may
prevent proper discharge and can result
in kickback of material through the
intake opening.
9. If the machine becomes clogged,
switch it off and remove the battery pack
from machine before cleaning the
debris.
10. Keep the power source clean of
debris and other accumulations to
prevent damage to the power source
and possible fire.