Sears CRAFTSMAN C950-52725-0 Owner's Manual page 15

The operation of any snowthrower can result in foreign objects being thrown into the eyes,which can
result in severe eye damage. Always wear safety glasses or eye shields before beginning snowthrower
Operation. We recommend standard safety glasses or Wide Vision Safety Mask for over spectacles.
SNOWTHROWER OPERATION
The most effective use of the snowthrower
established by experience, taking into consideration the
terrain, wind conditions and building location which will
determine the direction of the discharge chute.
NOTE: Do not blow snow towards a building as hidden
objects could be blown with sufficient force to cause
damage.
1. Start the engine as described in section "To Start Engine."
2. See Figure 15. Turn the remote deflector control counter-
clockwise to UNLOCK, and the spring (A) will pull the
deflector to the maximum throwing position (B). Pull
the knob UP to decrease the throwing distance.
3. Turn the remove deflector control knob clockwise to
LOCK in place when the desired angle has been
chosen.
4. Using crank, position the discharge chute to discharge
snow with the wind.
5. Select proper speed for snow conditions as outlined be-
low and set speed select lever to desired position.
NOTE: Always release traction drive clutch lever
before moving speed select lever.
Ground speed is determined by snow conditions. Select
the speed you desire by moving the speed selector into
the appropriate colored area on the control panel.
1- -2 Wet, Heavy, Slushy, Extra Deep
3 Moderate
4- -5 Very Light
6 Transport Only
NOTE: When clearing wet, heavy snow, it is
recommended that the ground speed of the unit be
reduced and do not attempt to clear the full width of
the unit.
1741613
OPERATION
For additional operating instructions see "Operating
Tips" in this section of the manual.
will be
6. Engage auger drive clutch lever (right hand--Figure 16).
IMPORTANT: Be sure front of unit is clear of
bystanders or obstacles before operating.
7. Engage traction drive clutch lever (left hand--Figure 16).
As the snow blower starts to move, maintain a firm hold
on the handles and guide the snowthrower along the
cutting path. Do not attempt to push the snow blower.
WARNING: Read Owner's Manual before oper-
ating machine. This machine can be dangerous
if used carelessly.
Never operate the snowthrower without all guards,
covers, and shields in place.
Never direct discharge towards windows or allow by-
standers near machine while engine is running.
Stop the engine whenever leaving the operating posi-
tion.
Disconnect spark plug before unclogging the impeller
housing or the discharge chute and before making re-
pairs or adjustments.
When leaving the machine, remove the safety key.
To reduce the risk of fire, keep the machine clean and
free from spilled gas, oil and debris.
Figure 15. Remote Deflector Control
A. Spring
B. Maximum Throwing Position
15
B
A
Figure 15