How To Install The Deflector; Control Knob; S N O W C H U T E A S S E M B L - Sears CRAFTSMAN C950-52725-0 Owner's Manual

HOW TO INSTALL
THE DEFLECTOR CONROL KNOB
1. Assemble the deflector control knob onto the deflector
control lever until snug against the nut (see Figure 10).
2. Make sure lip on the deflector control knob is pointed
toward the engine.
3. Tighten the nut against the bottom of the deflector

control knob.

SNOW CHUTE ASSEMBLY
1. Position the snow chute to the INSIDE of the snow
chute flange. Align the three holes in the snow
chute with holes in snow chute flange (see Figure 11).
2. Place three 5/16-18 carriage bolts from the inside of
the chute as shown in figure 11 (hardware is found
in parts bag).
3. Place three 5/16-18 flat washers and three 5/16-18
nuts on the outside of the flange.
4. First tighten the rear carriage bolt, then tighten the
remaining two carriage bolts. Make sure all carriage
bolts are tight.
5. Attach the remote snow chute deflector cable to the
weld stud (on deflector) and secure in place using
a pushnut as shown in Figure 12 (pushnut is found
in hardware bag).
NOTE: Before starting step 6 make sure that the chute
deflector is in the full open position and the remote
chute lever is in the full open position.
.
6. Attach the remote snow chute deflector cable
the cable chute bracket (see Figure 12) and secure
by tightening nuts (on cable) to the cable chute
bracket.
NOTE: Check all carriage bolts in flange for tightness.
DO NOT overtighten.
1741613
ASSEMBLY
Figure 11
Snow Chute Deflector Cable
Snow Chute Deflector
Snow Chute Deflector Cable
Figure 12
11
Deflector Control
Nut
Deflector Control Lever
Snow Chute Extension
Carriage Bolt
Flange
Nut
Pushnut
Knob
Figure 10
Flat Washer
Weld Stud
Cable Chute Bracket
Nuts