Table of Contents
Advertisement
Assembling the Leatherwork
Leg Assembly
Find bolts with washer and lock washer (A)
Stand both L-legs (B) upside down and bolt the
back support bar (C) to the back of the table legs
(1) Do not tighten down
A
Find treadle mount bar (D), bolts (E) and plates
(F) Place the treadle mount bar (D) 3-1/2 inches
(89cm) from the front toe of the legs (2) Bolt
each side of the treadle mount bar to the bottom
of the legs by placing plate (F) in the slot (G) and
using bolt (E) to secure
F
E
5 |
1
D
C
B
B
G
2
D
Sailritecom
Attaching Tabletop
On a soft surface, place the tabletop top side
down The recess (H) should be upright and to
your left With the back of the legs facing you,
place them on the tabletop and line up the
back pilot holes in the table with the leg mount
holes (I)
Loosely thread a hex head lag screw (J),
lock washer (K) and large flat washer (L) into
each back pilot hole (I) Then align the front
leg holes to their corresponding tabletop pilot
holes and thread in a screw (J), lock washer
(K) and flat washer (3, L)
Use a 3/8-inch socket wrench to tighten the
screws, compressing the lock washers (K)
Now tighten the four bolts (M) attaching the
back support bar (C)
The legs have adjustable feet (N) Rotate the
locking nut (O) in a manner allowing each foot
to be threaded all the way in Once the table
is upright this makes it easier to adjust one or
two feet to level the table Once adjusted, use
the nut to lock the position permanently
J
Leatherwork
Assembly Instructions
®
N
O
C
H
M
I
K
L
3
| 6
Advertisement
Table of Contents
