Epson PowerLite TW-100 User Manual page 37

Fine-tuning the Projector
32
2. Press the button on the control panel, or press down on the
button on the remote control, to highlight the Advanced
Select
menu and press the
Video
Advanced
Setting
About
Reset All
Select Enter
3. Use the , ,
button on the remote control to set the following options:
Select
Progressive (available for 480i and 575i image signals
only)
The projector automatically determines whether the input
signal is a film source or not, so it is best to leave this option
to the default
function. Turn it
interlaced mode to progressive (IP) conversion mode, for
example, when viewing images with a lot of movement. Select
when the input source is not a 24 FPS film source.
Video
Motion Detect (available for 480i and 575i image
signals only)
Use this option to adjust the amount of motion in a projected
image. Select a low setting (
sharpen images; this is best for still images. When viewing
fast moving images, such as sports, choose a higher setting
( or ) to project smoother images with less jerkiness.
4 5
button. You see these settings:
Select
Progressive
Select [ Film/Auto
Motion Detect 1 2 3 4
OFF NR1 NR2
Noise Reduction
Position
Adjust
Video Signal Select
Input A
Select
Input B
Select
0% 7.5%
Setup Level
Reset
Execute
, or buttons on the control panel or the
setting and use the 3/2 pull-down
Film/Auto
if you want to switch from the
OFF
or ) to reduce flickering and
1 2
]
5
[ Auto ]