Advertisement
Figure 2a
Check that the number of blue light flashes corresponds to the number of Alarms in
the system. If not see the "RadioLINK Troubleshooting" section below.
8. The Alarms will stay in House Code mode for 30 minutes and then reset
automatically. Alternatively they can be taken out of House Code mode by
removing one Alarm from its mounting plate and quickly pressing and holding the
House Code switch until the red light comes on solidly again. Release the switch
and the red light will go out immediately, indicating that the Alarm is no longer in
House Code mode. Replace the Alarm on the mounting plate. The blue light will
no longer be flashing.
Note: As this Alarm exits house code mode it sends a radio message to all the
other Alarms to exit the house code mode. Check that all the blue lights on the rest
of the Alarms have ceased flashing. (Accessories must be taken out of house code
manually - see their instructions).
RED LIGHT
HOUSECODE
SWITCH
5
Figure 2b
BLUE
LIGHT
Advertisement
