NRS Healthcare F24256 User Instructions

F24256 Medeci Bath Seat 152mm (6")
F24279 Medeci Bath Seat 305mm (12")
General Safety Warning
Please make sure that you read and follow
these instructions carefully. Keep these
instructions in a safe place for future reference.
1. INTENDED USE
The Medeci Bath seat is designed to provide a raised bathing seating position. It is secured to the base of
the bath using the sucker feet and to the sides of the bath with the non-slip rubber width adjusters.
It is often recommended that the Medeci Bath Seat is used in conjunction with a bath board.
2. SAFETY
Warning: The maximum user weight must not be
more than 190Kg (30st).
Ensure the bath and seat are clean and dry before
use.
Ensure all the bath seat sucker feet are securely
fixed and fitted flat on the base and not angled by
the curvature of the bath.
Do not attempt to remove the bath seat before
releasing the width adjusters and sucker feet, as this
may damage the bath seat.
Do not use in a highly sculptured or unusual shaped
bath, as the seat may not fit properly. The product is
not suitable for use in a bath with a textured base.
Always check the bath seat is securely fitted before
use.
3. UNPACKING
Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are
missing or damaged and do not try and assemble.
USER INSTRUCTIONS
MEDECI BATH STEP
F24268
4. ASSEMBLY/INSTALLATION
Ensure the bath is deep enough before fitting the
bath seat. It is important that the rubber ends of the
seat make a good tight contact against the flat part
of the bath side and away from any curvature.
Note: Before installation, ensure the bath and bath
seat sucker feet are completely dry and clean.
4.1 Adjust the width:
Make sure the seat is narrow enough to fit in the
bath by turning the adjuster wheels simultaneously.
1
Medeci Bath Seat 203mm (8")
Maximum User Weight
30st
190kg