Viking 300-IP Product Manual page 5

Step 1. Attach the round mounting plate base to wall, ceiling, post, etc. with appropriate fasteners (not included) (Diagram A).
Loosely attach the two side collars to the paging horn using the Philips head bolt, two washers, locking washer, and wing
Step 2.
nut (Diagram B).
Slide this assembly onto the mounting plate base (Diagram C). Loosely secure with remaining carriage bolt, washer,
Step 3.
locking washer, and wing nut (Diagram D).
Step 4. With both wing nuts loose, rotate and angle the horn into position, then tighten both wing nuts to secure.
Diagram A
(4) 0.217"
diameter 1.99"
1.99"
3.26"
Mounting Plate
Dimensions
Diagram C
www.VikingElectronics.com
Round Mounting
Plate Base
Screws
(not included)
Round
Mounting
Plate Base
VIKING
MODEL 300-IP
SIP / Multicast
Paging Horn
Status
Mounting
Washer
Wing
Nut
Lock
Washer
Wing
Nut
Lock
Washer
5
Diagram B
VIKING
MODEL 300-IP
SIP / Multicast
Paging Horn
www.VikingElectronics.com
Status
Washer
Side Collars
Diagram D
VIKING
MODEL 300-IP
SIP / Multicast
Paging Horn
www.VikingElectronics.com
Status
Washer Carriage
bolt
Phillips
head bolt