Table of Contents
Advertisement
20. Ext Relay Buzz Volume
The relay activation tone is a buzzing sound that is heard from the speaker when the door strike relay is activated.
After the caller enters the correct relay activation command, the caller will hear 2 short confirmation beeps and the
speaker will output a buzzing sound (relay activation tone) while the door strike relay is activated. The tone (buzz)
length will match the relay activation time up to a maximum of 5 seconds. The tone (buzz) can be programmed to three
different volume settings 1 = Low, 2 = Medium, 3 = High or it can be disabled. When disabled, the confirmation beeps
will not be heard. Factory Setting: 3
21. Ext Relay Latch Command
When set to "Enabled" the Operation Commands (Q0 to Q1) to Un-Latch or Latch the relay are enabled. These can be
entered on a inbound call after the access code is dialed (if programmed).
When set to "Disabled" the Operation Commands (Q0 to Q1) to Un-Latch or Latch the relay are disabled. Disabling the
latch commands can be useful in applications where you want to eliminate the possibility of inadvertently entering a
latch command leaving a gate open/closed, etc.
Factory Setting: Enabled
22. SIP Paging Volume
The SIP Paging volume can be set from 0 - 19. 0 = lowest volume setting, 19= highest volume setting. Adjusting this
will set the Speaker volume level for SIP Paging. This setting does not affect multicast volume settings.
Factory Setting: 1
23. Ring Volume
When the Inbound Call mode is set to Ring or Night Ring timed operation is in effect, the 300-IP will output a loud ring
when it is called. The level can be adjusted from 0 - 19. Factory Setting: 5
24. SIP Page Length Timeout
This feature selects the maximum length of time that SIP Paging calls can be connected. Programmable in increments
of 1 minute up to a maximum of 9 minutes or disabled. With the SIP aging length disabled, the 300-IP paging horn
must rely on a call ended signal or touch tone # to hang-up. Factory Setting: 3 minutes
25. Multicast Page Timeout
The Multicast Page Length Timeout can be programmed from 1 - 255 seconds in one second increments. The Time
Out can be disabled, allowing any length of page or continuous background music. Only one timeout time can be
programmed for all multicast paging groups. When using standard Multicast Paging, a timeout checkbox can be selected
for each paging group. When using Polycom Multicast Paging, the timeout checkbox enables the timeout globally on
groups 1 through 24. There is no timeout for a page to the emergency group 25.
Factory Setting: 180 seconds
26. Inbound Call Mode
The Inbound Call Mode determines how the 300-IP handles incoming SIP calls. One option is to generate a loud ring
sound through the speaker. The 300-IP can also auto answer a SIP call to transmit a page or control the relay. The
"secure" options for auto answer require the callers to dial the access code in order to transmit a page or activate the
optional RC-4A relays. Factory Setting: Auto Answer
Disabled: Inbound SIP calls are not allowed. For more security use the Auto Answer Secure Mode.
Auto Answer: Inbound calls are auto answered on the first ring. For more security use the Auto Answer Secure Mode.
Auto Answer Secure: Inbound SIP calls are auto answered and the caller must dial the access code in order to make
a SIP page.
Ring: In the "Ring" mode the speaker phone will not automatically answer an incoming call but will output a loud ring
signal out of the speaker in a factory programmed 2 seconds ON, 4 seconds OFF ring pattern. There are four available
ring cadences.
16
Advertisement
Table of Contents
