ESAB PCM-1125 Instruction Manual page 12

SECTION 2
Allow at least 10 ft. (3m)
between work and power source
WORK
SAFETY
GROUND
PT-27
CUSTOMER FUSED LINE
DISCONNECT SWITCH(See
Table 2.1 and WARNING in
regards to chassis ground in
Section 2.5.)
CNC INTERFACE CONNECTION
(INSIDE ON LEFT SIDE OF BASE.)
DETAIL "A"
Prefiltered AIR SUPPLY
(Customer Supplied)
(90 to 150 psig max)
Figure 2-1. PCM-1125 Interconnection Diagram
ACCESS DOOR FOR
TORCH CONNECTION
ACCESS FOR CNC
INTERFACE CONNEC-
TIONS.
(See Detail "A")
INPUT POWER CABLE
(See Table 2.1)
NOTE: The 208/230 V model is equipped with a plug for single-
phase connection only. The plug is mounted to a 4-
conductor cable. If 3-phase connection is desired, remove
and discard the plug and refer to Sect. 2.5.
12
INSTALLATION
TORCH
PILOT
ARC
CONNECTION
TORCH
POWER
CABLE
CONNECTION
TORCH
SWITCH
RECEPTACLE