Daikin FVXM25A2V1B Installation Manual page 6

5 Unit installation
Floor-standing installation
A
a
a
b
C
e
a
5‒1 Indoor unit installation drawing: Floor-standing installation
A Front view
B Side view
C Top view
a Screw hole 6×
b Left-back piping hole location
c Right-back piping hole location
d Left/right piping hole location
e Left-bottom piping hole location
f Right-bottom piping hole location
1 Drill a wall hole, depending on which side piping is taken out.
hole" [ 4 8].
See "5.3.2 To drill a wall
2 Open the front panel and remove the front grille (see
unit" [ 4 4]).
"5.2 Opening the indoor
3 Remove the slit portions using nippers. See
portions" [ 4 8].
the slit
4 Secure the unit to the wall and floor using 6 screws M4×25L
(field supply).
6×
5 When the complete installation is finished, attach the front panel
and the front grille in their original position.
Installation manual
6
B
a
a
d
c
f
a
(mm)
"5.3.3 To remove
Wall-mounted installation
A
a
b
b
d
c
C
g
5‒2 Indoor unit installation drawing: Wall-mounted installation
A Front view
B Side view
C Top view
a Mounting plate
b Screw hole 4×
c Floor
d Left-back piping hole location
e Right-back piping hole location
f Left/right piping hole location
g Left-bottom piping hole location
h Right-bottom piping hole location
6 Temporarily secure the mounting plate on the wall.
7 Make sure the mounting plate is level.
8 Mark the centres of the drilling points on the wall.
9 Secure the mounting plate on the wall using 5 screws M4×25L
(field supply).
5×
10 Drill a wall hole, depending on which side piping is taken out.
hole" [ 4 8].
See "5.3.2 To drill a wall
11 Open the front panel and remove the front grille (see
"5.2 Opening the indoor unit" [ 4 4]).
12 Remove the slit portions using nippers. See
portions" [ 4 8].
the slit
13 If necessary for the skirting board, remove the slit portion on the
bottom frame.
B
b
b
f
e
c
h
(mm)
"5.3.3 To remove
CVXM20A + FVXM25~50A
Split system air conditioners
3P477070-2M – 2021.09