Using The Remote Control; Adjust The Image - Epson PowerLite 1835 Quick Setup

4
Press the power button on the projector or remote control.
Power button
Power light
The power light flashes green, then stays on.
Note: To shut down the projector, press the
unplug it. You don't have to wait for the projector to cool down.
5
The default language of the menu system is English. To select another
language, press the Menu button on the remote control. Select
Extended and press Enter. Select Language and press Enter. Select your
language and press Enter. Press the Menu to exit the menu system.

Adjust the image

1
If you don't see an image, press the Source Search button on the
projector or the remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
2
To raise the image, press the foot release button and lift the front of the
projector. Release the button to lock the foot in position.
3
Rotate the focus ring to sharpen the image.
Focus ring
4
Turn the zoom ring to reduce or enlarge the image.
Zoom ring
5
If your image looks like or
one side of the screen at an angle. Place it directly in front of the center
of the screen, facing the screen squarely. Or press the
the projector to correct it.
6
If your image looks like or
projector to correct it.
power button twice, then
, you've placed the projector off to
or buttons on
, press the or buttons on the

Using the remote control

Make sure the batteries are installed as shown (two AA batteries).
Turn projector
on and off
Turn off projector
display and sound
Access projector
menus
For more information on using the remote control, see the User's Guide on
your projector CD.
Project wirelessly
Follow the steps here to connect the projector wirelessly over an 802.11g,
802.11b, or 802.11n wireless network. You must install the optional Epson
wireless LAN module (part number V12H418P12). Your computer must have
a wireless card or built-in wireless interface, and be running Windows 7,
Windows Vista ® , Windows XP Professional x64, Windows XP, or Windows 2000,
or Mac OS X 10.3 to 10.6.
1
Turn off the projector and unplug the power cord.
2
Slide the air filter cover latch and open the air filter cover.
3
Remove the screw securing the wireless LAN module stopper, then
remove the stopper.
4
Insert the wireless LAN module into the port.
Choose which source
to display
Control projector
volume
Navigate projector
menus