Advertisement
Conduct reassembly by reversing the disassembly procedure but note the following.
1. Reassembly of the power supply section
• Reassembly of the power supply section (1)
Position the lever to the inside.
Do not put the signal wire on
the above areas to avoid being
caught by housing (B).
Reassembly
Fit the flange in the groove.
Put the ribbon cable
to the left of the
noise suppressor.
Fit the internal wire in
the groove completely.
Noise suppressor*
Face the LED forward.
A
Enlarged view from "A"
Housing (B) ←
*: Push the noise suppressor in until it
reaches the stepped portion of
housing (A) facing the internal wire of
the noise suppressor to housing (A).
-4-
Align the corner of
the stator insulator
with the corner of
the housing.
Put one red internal wire and one
black internal wire to the right of
the noise suppressor.
Fit the rib of the
housing in the groove
of the battery terminal.
→ Housing (A)
Internal wire
Stepped portion of
housing (A)
Advertisement
