Advertisement
• Reassembly of the power supply section (2)
Fit the protrusions of the Stator FET PCB Ass'y [6] in the mating portions of the housing.
2. Mounting the flexible shaft
(1) Fix the shaft sleeve with pliers. Tighten the shaft of the Rotor Ass'y [5] with a wrench (8 mm) fitting on
its width across flats portion until it contacts the shaft sleeve as shown in the figure below.
• Mounting the flexible shaft
(2) Tighten the hose gland while keeping the Front Cover [2] in contact with the flexible hose. If there is any
clearance between them, the tip of the flexible shaft is not fitted in the mating portion properly. Wrap the
hose gland with a cloth and tap the corner with a hammer to tighten it.
Front Cover [2]
Width across flats portion
of the shaft (8 mm)
Contact
Keep the Front Cover [2] in
contact with the flexible hose.
Flexible hose
Shaft sleeve
Fix it with pliers.
Hose gland
-5-
Corner
Tighten.
Advertisement
