Use Of The Appliance; Setting The Water Softener - Electrolux ESL63010 User Manual

18 electrolux
Setting mode
The appliance must be in setting mode
for these operations:
• To select and start a washing pro-
gramme.
• To adjust electronically the level of the
water softener.
• To deactivate/activate the audible sig-
nals.
Press the on/off button. The appliance
is in setting mode when:
• All the programme lights are off and the
end-of-programme indicator light flashes.
Press the on/off button. The appliance
is not in setting mode when:
• Only one programme light comes on.
– It is necessary to cancel the pro-
gramme to go back to the setting
mode. Refer to 'Select and start a
washing programme'.
Audible signals
You can hear the audible signals when:
• The washing programme ends.
• The appliance has a malfunction.
Do these steps to deactivate the audible
signals:
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold the programme button
until the programme light A flashes and
the programme light B comes on.

USE OF THE APPLIANCE

1. Be sure that the set level of the water
softener agrees with the water hardness
in your area. If not, adjust the water
softener.
2. Fill the salt container with dishwasher
salt.
3. Fill the rinse aid dispenser with rinse aid.

SETTING THE WATER SOFTENER

The water softener removes minerals and
salts from the water supply. These minerals
and salts can cause damage to the appli-
ance.
4. When the programme light A flashes
and the programme light B comes on,
press immediately the programme but-
ton again.
The programme light A comes on and
the programme light B starts to flash.
After some seconds the programme
light A goes off and the end-of-pro-
gramme indicator light comes on. (The
programme light B continues to flash).
– The audible signals are active.
5. Press the programme button again. The
end-of-programme indicator light goes
off.
– The audible signals are deactivated.
6. Switch of the appliance to confirm the
operation.
Do these steps to activate again the audible
signals:
1. Follow the procedure how to deactivate
the audible signals from point 1 to point
4.
2. The programme light A goes off. The
end-of-programme indicator light is off.
(The programme light B continues to
flash).
– The audible signals are deactivated.
3. Press the programme button again. The
end-of-programme indicator light comes
on.
– The audible signals are active.
4. Switch of the appliance to confirm the
operation.
4. Load cutlery and dishes into the appli-
ance.
5. Set the correct washing programme for
the type of load and soil.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing programme.
Adjust the level of the water softener if this
does not agree with the water hardness in
your area.
Contact your local water authority to know
the water hardness in your area.