Reebok RX 820 User Manual page 7

4. Locate the Belly Pan Wire Harness (124). Route the Belly
Pan Wire Harness over the Base (117) as shown.
Connect the Belly Pan Wire Harness to the Wire Harness
(55). Be sure to insert the connectors properly (see
drawing 4a). IF THE CONNECTORS ARE NOT IN-
SERTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON. The con-
nectors should slide together easily and snap into
place. If the connectors do not slide easily and snap into
place, turn a connector and try again.
See drawing 4b. Carefully wrap the wires around the con-
nectors as shown. Insert the connectors and the excess
Wire Harness into the Right Upright (58).
With the help of another person, carefully tip the treadmill
onto its other side. Attach the Left Upright, the other Base
Leg, the left Front Wheel, and the other Base Pads (not
shown) as described in steps 1 through 3. (Note: There is
not a wire harness in the Left Upright.) Do not fully
tighten the bolts yet.
5. With the help of another person, carefully raise the
Uprights (35, 58) to the vertical position, with the wheels
and the walking platform on the floor as shown on page 5.
Have the other person hold a Handgrip Post (41) on the
Left Upright (35) as shown. Hold a Post Spacer (43) in-
side of the Handgrip Post. Insert a Post Bolt (44) with a
1/4" Washer (125) through the end hole in the Handgrip
Post and through the Post Spacer. Finger tighten the
Post Bolt. Finger tighten another Post Bolt (44) with a 1/4"
Washer (125) into the other hole. If necessary, tap the
Handgrip Post with a rubber mallet to make sure that it is
fully seated. Tighten the Post Bolt in the end hole.
Then, tighten the other Post Bolt.
Attach the other Handgrip Post (41) to the right Upright
(not shown) as described above.
6. Have another person hold the Console Base (52) near
the Uprights (35, 58). Locate the wire harness extending
from the Console Base. Connect the wire harness to the
Wire Harness (55) in the Right Upright. If the connectors
do not fit together easily, rotate them and then con-
nect them. Carefully feed the connectors and the excess
wire harness into the Right Upright. Carefully set the
Console Base on the posts on the Uprights.
Finger tighten four Console Bolts (42) with four Star
Washers (113) into the Uprights (35, 58) and the Console
Base (52). After all four Console Bolts have been started,
tighten them.
See step 1. Tighten the two Upright Bolts (66). See
step 2. Tighten the four Base Leg Bolts (77). Make
sure that the Base Leg Nuts (70) are fully seated in
the square holes. Note: It may be helpful to tip the
treadmill onto its side to tighten the Base Leg Bolts.
All manuals and user guides at all-guides.com
7
4
55 124
117
4b
4a
5
44
125
43
End
Hole
35
6
Wire Harness
113
55
42
58
58
41
52
113
42
35