Maintenance Of The Hair Styler - Panasonic EH‑KE46 Operating Instructions Manual

Maintenance of the hair styler

• Make sure to check the air inlet and air outlet at least once
every month, performing maintenance as needed.
Dust or other foreign debris may build up and block these
areas causing a degradation in performance as well as the
following issues.
• When the hair styler is blowing hot air, occasionally it may
turn off or sparks may be seen. In such cases, dust may
have accumulated at the air inlet and/or the air outlet. Also,
the air inlet may be being blocked by your hair, hands, etc.
(This phenomenon is the result of the hair styler's thermal
switch. It is a protective device. The sparks do not pose a
danger in and/or themselves.) Slide the power switch to the
"0" position and remove the dust if dust has accumulated, or
if air inlet was blocked by your hair or hand, cool down the
hair styler for approximately 5 minutes before using it again.
• Make sure to turn OFF the power switch and disconnect the
plug from the household outlet. (Except when performing
maintenance on the air outlet)
Maintaining the main body
Clean the housing only with a soft cloth
slightly dampened with tap water or soapy
tap water.
Notes
• Do not use thinner, benzine, alcohol or other chemicals.
- Doing so may cause malfunction, cracking/discoloration
of parts etc.
• Leaving the hair styler with hair products or makeup still
adhered to the handle or body may degrade the plastic,
causing discoloration or cracking, and malfunction.
Maintaining the attachments
Remove dust and hair using a commercially available brush,
and clean with a hair styling product.
Notes
• As a precaution, allow the hair styler to cool before
removing attachments.
• After cleaning, allow the hair styler to dry sufficiently before
use.
11