Replacing The Maintenance Tank; Related Documentation - Epson Stylus Pro 10600 Product Information

Epson stylus pro 10600: product information

Hide thumbs Also See for Stylus Pro 10600:

Table of Contents

EPSON Stylus Pro 10600

8. Insert the new cutter.

9. Push down on the cutter's side pin while turning the latch

to the left.

10. Close the lower cover. The print head returns to the home

position.

16 - EPSON Stylus Pro 10600

Replacing the Maintenance Tank

When the maintenance tank is nearly full, the printer displays

the following message on the control panel:

MAINTENANCE REQ. 0100

You should call to schedule service at this point. When the

waste ink system is at full capacity, the printer stops and

displays the following message:

SERVICE REQ. 00000100

Approximately every two years of normal usage (25% duty

cycle) or after 20,000 B0-size prints, you should have your

authorized EPSON servicer replace the waste ink system. This

is necessary to prevent damage to the print head and maintain

print quality. Parts and labor for this service are not covered

under the terms of the limited warranty.

You can monitor the status of the waste ink system by printing

the status check sheet (see page 9); a low value (or a value near

Empty) indicates that the pad is nearing the end of its service

life.