Loading Envelopes; Loading Roll Paper - Epson Stylus Photo R800 Product Information

Epson Stylus Photo R800

Loading Envelopes

You can load up to 10 envelopes at a time, as described below.
For best results, press each envelope flat before loading it, or
load one envelope at a time.
1. Open the paper support and slide out the support extension
2. Open the output tray and its extensions. Make sure the tray
is in the lower position.
3. Load envelopes short edge first as shown, with the flap side
down and the flap edge facing left.
4. Slide the left edge guide against the envelopes.
5. Choose these settings in your printer software:
❏
as the Type (Windows) or Media Type
Plain Paper
(Macintosh) setting
❏ The envelope size as the Size (Windows) or Paper Size
(Macintosh) setting
❏
as the Orientation setting
Landscape
If printing is smeared on your envelope or on other thick
paper, select the
Thick paper and envelopes
your printer software.
Epson Stylus Photo R800
8 -

Loading Roll Paper

You can load 4-inch and 8.3-inch wide roll paper for printing
multiple photos or panoramics, with or without borders.
It's a good idea to check and make sure your ink cartridges are
not low before loading and printing on roll paper. If you need
to replace a cartridge with roll paper loaded, you should
remove the paper or marks may appear in your printout.
1. Turn on the printer and remove any paper loaded in the
2. Open the output tray, but don't pull out the extension. Also
3. Place the roll paper on the holders as shown, then remove
checkbox in
4. Make sure the end of the paper is cut straight across, with
1/04
sheet feeder at the top of the printer.
make sure the tray is in the lower position.
any tape and protective paper from the end of the roll.
90° corners. If the end is cut diagonally, you may have
problems feeding the paper.