Pro-Form C42 User Manual page 6

3. Insert a Plastic Shim (97) into each side of the post on
the right side of the Base (11). Next, orient the Right
Upright (62) as shown, and insert it into the Base. Make
sure that the Wire Harness (21) does not fall into the
Right Upright. Be careful to avoid pinching the Wire
Harness. Note: If necessary, tap the Right Upright with a
rubber mallet until it is fully seated in the Base. If the
Right Upright cannot be fully seated, remove the outer
Plastic Shim and then insert the Right Upright.
Attach the Right Upright (62) to the Base (11) with three
1" Bolts (8) and three Star Washers (9). Do not tighten
the Bolts yet.
Assemble the Left Upright (not shown) in the same way.
4. Hold the Crossbar (34) between the Uprights (62, 76).
Attach the Crossbar with two 2 1/2" Bolts (53) and two
5/16" Washers (57). Do not tighten the Bolts yet.
5. Feed the Wire Harness (21) up into the rectangular
bracket on one of the Handrails (1) and out the large hole
in the left side. Note: It may be helpful to use needlenose
pliers to pull the Wire Harness out of the large hole.
Remove any plastic ties that are in the rectangular
bracket on the Handrail (1). Insert the bracket into the top
of the Right Upright (62). Attach the upper and lower
ends of the Handrail to the Right Upright with two 1"
Bolts (8). Do not tighten the Bolts yet.
Attach the other Handrail (1) as described above. Note:
There is not a wire harness on the left side.
Attach the end of the ground wire to the small hole in the
side of the right Handrail (1) with a Silver Ground Screw
(96).
3
4
53
57
5
1
8
6
21
This hole
must be
on this side.
9
97
9
11
8
34
57
76
62
Ground
8
21
Wire
96
Large
Hole
1
76 Bracket
62
8
62
8
53
8