Deleting Fingerprints; Using The Micro-Usb Port; Backup Key Access - Vaultek LifePod 2.0 Instruction Manual

Biometric Scanner Programming: Enrolling Additional Prints 3-20
With both admin prints enrolled, you can enroll additional users. This safe can store up to a total
of 20 different fingerprints.
Open the safe lid, and wake LifePod ® by tapping the lock pad so all the keys light up RED. While
LifePod is awake, quickly tap the program button to get keypad flashing RED. This is prompting
®
the scan of an admin print to authorize the request to enroll a new user. Scan one of the enrolled
admin prints to authorize enrolling a new user.
Registration Scan 1: With the 1 key now blinking, place the new finger on the scanner and remove
it when the status LED turns GREEN and you hear a confirmation beep.
Registration Scan 2: With the 2 key now blinking, place the same finger on the scanner at a slightly
different angle and remove it when the status LED turns GREEN and you hear a confirmation beep.
Registration Scan 3: With the 3 key now blinking, place the same finger on the scanner at a slightly
different angle then remove it when the status LED turns GREEN and you hear a confirmation beep.
Registration Scan 4: With the 4 key now blinking, place the same finger on the scanner at a slightly
different angle then remove it when the status LED turns GREEN and you hear a confirmation beep.
This completes enrollment for a new single user.
Repeat steps 1-5 to enroll additional prints.
Continue on next page to learn how to delete fingerprints.
13 Vaultek
®

Deleting Fingerprints

To delete all the stored prints on the LifePod
keys light up RED. Immediately, press and hold keys '1' and '3' together for 3 seconds (until all
the keys turn RED) then enter your master code to delete all fingerprint IDs.

Using the Micro-USB Port

In the event the battery dies while traveling, and you do not have access to the
backup keys, you can power on the unit using the backup micro-USB port.
Simply open the front protective rubber cover behind (Fig I) and plug in a micro-
USB cable (not included) into the port. While the cable is plugged into an external power source,
LifePod will function normally allowing you to enter the code and open the unit.
®

Backup Key Access

Backup keys can not lock LifePod . Backup keys are provided in
®
case of electronic failure, allowing you to unlock LifePod
keyhole is located beneath the front protective rubber cover (Fig I).
To unlock LifePod ® , simply open the protective cover (Fig I), insert
one of the backup keys, and turn the key clockwise 90 degrees. If
the Anti-Picking feature is enabled, the backup keys can not open
LifePod . See page 16 for details.
®
® , wake the unit by tapping the lock pad so all the
I
IMPORTANT! Always make
sure the front protective
® . The
cover is closed tightly to
ensure the unit is sealed
correctly for protection from
the elements.
14 Vaultek
®