Emptying The Dust Cup; Replacing Filters - Shark ZD400 Series Owner's Manual

EMPTYING THE DUST CUP

IMPORTANT: Unplug the power cord before performing any maintenance.
Empty the dust cup each time you vacuum and periodically during cleaning,
when debris in the dust cup reaches the MAX fill line.
To remove Dust Cup, lift tabs on both sides
of dust cup handle. Tilt dust cup, then lift
to remove.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
s h a r kc l e a n . c o m
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals.
Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid
from being drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Filter
Felt
Filter
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.

REPLACING FILTERS

Follow instructions for removing filters. The Pre-Motor Filter should be replaced every 2.5 years.
The HEPA Filter should be replaced every 3 years.
Replacement
Pre-Motor Foam
s& Felt Filter Kit
XFFKZD400
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
FPO
Filter Post-Motor
Door Filter (HEPA)
CLEAN HEPA FILTER
EVERY YEAR
Press button at bottom of Filter Door. Tilt
filter door and lift out. Remove HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
Replacement
HEPA Filter
XHFZD400
s h a r kc l e a n . c o m