Cleaning Modes - Shark ZD400 Series Owner's Manual

WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Off
I Hard Floor
For bare floors and small area rugs.
II Carpet
For carpets.
NOTE: Brushroll spins in all modes.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as it should.
Solid Red: There is a jam in the brushroll area. Turn your vacuum off, unplug from the wall and
remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets), use Carpet setting and set suction control to MAX.
s h a r kc l e a n . c o m
SETTINGS
SUCTION CONTROL
Suction Control offers variable suction
based on your needs. Slide to MIN to reduce
suction and increase maneuverability on
carpets. Slide to MAX to increase suction on
bare floors.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushroll, turn power on,
then step on floor nozzle and tilt
handle back.
LIFT-AWAY® MODE
Press the Lift-Away button to detach
the pod from the floor nozzle.
ABOVE-FLOOR—HANDLE
Press the Handle Release button on the back
of the wand to detach the handle from the wand.
NOTE: All accessories are compatible with both the wand and the handle.
LIFT-AWAY® WAND
With the pod removed, press the Wand
Release button to detach the wand from
the pod.
s h a r kc l e a n . c o m