Table of Contents
Advertisement
Quick Links
PATIO HEATER
Model No. PH2160, PH2165 & PH2169
The ideal solution for extending the season for
outdoor entertaining
Direct ignition
Maximum output 40MJ/h
Adjustable heat output
Operates for approximately 9 hours on a
properly filled 9Kg propane cylinder
Includes a safety 'tip-over'switch that halts
supply of gas to the unit should it be accidently
knocked over
Flame safeguard system for enhanced safety
Durable and weather resistant
Complete with hose and regulator
For outdoor use only
Includes hose and regulator
Certified to Australian standards
FOR YOUR SAFETY
If you smell gas:
1.
Shut off the gas to the appliance.
2.
Extinguish any open flame.
3.
If odour continues, immediately call your gas supplier.
Do not store or use gasoline or other flammable vapour and
liquids in the vicinity of this or any other appliance.
FOR OUTDOOR USE ONLY
PROPANE GAS
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Read the instructions thoroughly before installing or
servicing this equipment.
03366 10/15
Important: Retain these instructions for future use.
Advertisement
Table of Contents
Related Manuals for Gasmate PH2160
Summary of Contents for Gasmate PH2160
- Page 1 PATIO HEATER Model No. PH2160, PH2165 & PH2169 The ideal solution for extending the season for outdoor entertaining Direct ignition Maximum output 40MJ/h Adjustable heat output Operates for approximately 9 hours on a properly filled 9Kg propane cylinder Includes a safety ‘tip-over’switch that halts...
-
Page 2: Customer Service
INSTALLATION, OPERATION & MAINTENANcE INSTRUcTIONS Prior to assembling your appliance, the following must be reviewed. Compliance with the following should result in satisfactory heater operation. This instruction IMPORTANT SAFETY RULES manual should be retained for future reference. The This appliance must only be used in a well installation must conform with local codes or authority ventilated area. - Page 3 INSTALLATION - OUTDOOR USE ONLY The flame pattern at the emitter grid should be 13. The heater has been designed with several safety visually checked whenever heater is operated. features which include a tip over switch. If flames extend beyond surface of the emitter NOTE: The plastic container in the base must be filled grid or black spot is accumulating on the with sand before use.
- Page 4 PATIO HEATER - FOR OUTDOOR USE ONLY Minimum clearance from combustible Surfaces*: 750mm Burner head Cylinder housing 440mm *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
-
Page 5: Reflector Assembly
REFLEcTOR ASSEMBLY 1. Place the 3 parts of reflector segments to overlap together and attach with 3 screws, washers and nuts. 2. Place round part of reflector over the 3 segments and attach with 6 screws, washers and nuts. -
Page 6: Tools Required
ASSEMBLY INSTRUcTIONS Note: Remove any transit protection material. Tools required Adjustable spanner. Step 1 1-1. Put the 3 post brackets on each position on the base as shown in the picture. 1-2. Use 3 M8 x 16mm bolts to join the post brackets and base. -
Page 7: Troubleshooting
TEST FIRING HEATER Test fire heater, following the lighting instructions on heater post. Leak test all gas connections with soapy water. Soap bubbles indicate gas leakage. DO NOT use a match to test for gas leaks. TROUBLE SHOOTING Problem Possible causes Main burner will not light No gas Low gas pressure... -
Page 8: Safe Appliance Locations
SAFE APPLIANcE LOcATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with one of the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1).