Subscribe to Our Youtube Channel
Related Manuals for Clarke IG2200A
Summary of Contents for Clarke IG2200A
- Page 1 2.2KW INVERTER GENERATOR MODEL NO: IG2200A PART NO: 8877120 OPERATION & MAINTENANCE INSTRUCTIONS LS0919 - ISS 1...
-
Page 2: Introduction
INTRODUCTION Thank you for purchasing this CLARKE 2.2kW Inverter Generator Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Table Of Contents
TABLE OF CONTENTS INTRODUCTION ..............2 GUARANTEE ...............2 ENVIRONMENTAL RECYCLING POLICY ......2 TABLE OF CONTENTS ............3 GENERAL SAFETY RULES ...........4 Work area ..................4 Positioning the generator .............. 4 Fire prevention ................4 Prevention of electric shock ............5 Additional safety rules for generators .......... 5 SAFETY SYMBOLS ...............6 GENERATOR OVERVIEW ............7 UNPACKING AND ASSEMBLY ...........8... -
Page 4: General Safety Rules
GENERAL SAFETY RULES WARNING: EXHAUST FUMES CAN BE EXTREMELY DANGEROUS IF INHALED WORK AREA • Always use in a well ventilated area. • Always position the exhaust outlet away from people. • Read these safety instructions before using the equipment. •... -
Page 5: Prevention Of Electric Shock
5. Never start the engine if there is spilled fuel. Any spillage must be wiped clean and the generator allowed to dry before attempting to start the engine. PREVENTION OF ELECTRIC SHOCK 1. Never use the generator in wet conditions unless it is well protected/ covered. -
Page 6: Safety Symbols
SAFETY SYMBOLS Caution - The user should be aware of a general hazard Dangerous Voltage Flammable Hot Surface - Do not touch Poisonous fumes - Do not use the generator in an enclosed space. Read Instruction manual before use. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 7: Generator Overview
GENERATOR OVERVIEW DESCRIPTION NO DESCRIPTION Air Vent Knob Earthing Point Fuel Cap Economy Control Switch Fuel Valve Knob AC Sockets Starting Handle DC Socket Left Side Maintenance Cover DC Circuit Breaker Top Maintenance Cover Overload Indicator Muffler Output Indicator Choke Oil Alarm Indicator Engine ON/OFF Switch Primer Bulb... -
Page 8: Unpacking And Assembly
UNPACKING AND ASSEMBLY Unpack your Generator and check the following items are present. Should there be any missing or damaged during transit contact your CLARKE dealer immediately. • 1 x 2kW Inverter Generator • 1 x Spark Plug Box Spanner •... -
Page 9: Checking The Air Filter
3. Slide out the air filter cover. 4. Remove the air filter element. 5. If the air filter is damaged contact CLARKE spare parts department for a replacement. • If the filter is dirty, wash it in a solution of warm water and mild detergent and rinse thoroughly. -
Page 10: Check The Engine Oil Level
CHECK THE ENGINE OIL LEVEL WARNING: YOUR GENERATOR MAY NOT BE SUPPLIED WITH OIL, ALWAYS ENSURE THAT THERE IS SUFFICIENT OIL BEFORE USE. WARNING: TO CARRY OUT THIS CHECK, THE ENGINE MUST BE OFF. NOTE: Place the generator on a level surface and check the oil level as follows. -
Page 11: Check The Fuel Level
CHECK THE FUEL LEVEL WARNING: MAKE SURE THERE IS FUEL IN THE TANK WHEN USING THE GENERATOR. RUNNING OUT OF FUEL OR STOPPING THE ENGINE SUDDENLY WITH A LOAD CONNECTED COULD CAUSE SERIOUS DAMAGE. To check the fuel level, open the Fuel filler cap fuel filler cap. -
Page 12: Using Your Generator
USING YOUR GENERATOR STARTING THE ENGINE 1. Remove all connections from the AC sockets. Hold the fuel tank cap so that it Air vent knob will not move, and turn the air vent knob to the ON position. 3. Turn fuel valve to the ON position (pointing downwards). - Page 13 NOTE: When you first start the generator, the overload indicator may light up for a few seconds, this is normal. If the overload indicator is still lit after 5 seconds, stop the engine and contact your CLARKE dealer. 8. Once the engine has warmed up, move the choke to the right.
-
Page 14: Connecting Electrical Devices
CONNECTING ELECTRICAL DEVICES The generator can supply both 230V AC and 12V DC AC POWER 1. Start the engine. See page 12. 2. Make sure the appliance is turned off before connecting it to the generator. 3. Connect the appliance to the generator. - Page 15 DC POWER (FOR CHARGING CAR BATTERIES ONLY) WARNING: FOR YOUR SAFETY PERFORM THE FOLLOWING INSTRUCTIONS IN THE ORDER SHOWN. 1. Set the economy control switch to ‘OFF’. 2. Start the generator. See page 12. 3. Connect the battery charging leads to the battery. •...
-
Page 16: Economy Switch
ECONOMY SWITCH When the economy control switch is turned on, the engine speed varies according to the load connected. This results in decreased fuel consumption and less noise. When the economy control switch is turned off, the engine runs at the 5,000 r/min. -
Page 17: Shutting Down The Generator
SHUTTING DOWN THE GENERATOR To stop the generator in an emergency simply set the engine switch to ‘OFF’. NOTE: Turn off any electric devices. NOTE: Set the economy control switch to the ‘0’ (OFF) position. 1. Disconnect any electric devices. 2. -
Page 18: Maintenance
MAINTENANCE ENGINE OIL (EVERY 20 HOURS OF USE) CAUTION: PROLONGED EXPOSURE TO USED ENGINE OIL IS DANGEROUS, ALWAYS WASH YOUR HANDS THOROUGHLY AFTER HANDLING USED ENGINE OIL. 1. Remove the maintenance panel shown on the right. 2. Turn the oil filler cap anti- clockwise and remove from the oil tank. -
Page 19: Air Filter (Every 50 Hours Of Use)
3. Pull out the air filter cover. 4. Remove the air filter element. 5. If the air filter is damaged contact CLARKE spare parts department for a replacement. • If the filter is dirty, wash it in a solution of warm water and mild detergent and then rinse thoroughly. -
Page 20: Spark Plug (Every 50 Hours Of Use)
SPARK PLUG (EVERY 50 HOURS OF USE) CAUTION: ALLOW THE ENGINE TO COOL BEFORE REMOVING THE SPARK PLUG. 1. Remove the top maintenance panel. 2. Remove the spark plug cap from the spark plug. 3. Assemble the spark plug spanner as shown. -
Page 21: Fuel Tank Filter
7. Check the overall condition of the spark plug and replace if damaged. NOTE: Spark plugs are available from CLARKE Spare Parts department 020 8988 7400. 8. Reinstall the spark plug and replace the spark plug cap. FUEL TANK FILTER Just inside the fuel tank is a fuel filter, check this filter periodically and remove any contaminants which may have accumulated. -
Page 22: Troubleshooting
The air filter is dirty Clean the air filter. See page 19 The generator is difficult to start If this does not solve your problem, please contact the CLARKE service department. see below. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 23: Specifications
SPECIFICATIONS IG2200A ENGINE Engine Model 152F Forced air cooled Type 4-stroke gasoline Displacement (cm Ignition type T.D.I Fuel tank capacity (L) Maximum run time at 3/4 load (h) Engine oil capacity (L) 0.45 Guaranteed sound power (L 92dB GENERATOR Rated Frequency (Hz) -
Page 24: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 25: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 26: Notes
NOTES Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 27: Notes
NOTES Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the IG2200A and is the answer not in the manual?
Questions and answers