Epson Stylus Color Stylus Color IIs User Manual page 9

4. Raise the blue print head unit release lever as far as it will
go.
release lever
Caution:
c
Do not lift up the ink cartridge clamp; the ink cartridge
and print head may become unusable.
5. Grasp both sides of the print head unit and carefully lift it out
of the printer. Place the print head unit on a flat, clean
surface.
Caution:
c
Do not touch the electrical contacts on the back and bottom
of the print head unit or inside the printer; you may
damage them.
6. Remove the monochrome print head unit from its storage
box by pressing on the notch as shown. Place the color
print head unit in the box. Always store the unused print
head unit in this box to protect its delicate components.
Ink Jet Printers
7. Carefully insert the monochrome print head unit into the
printer with the electrical contacts and print head facing
the back of the printer.
8. When the print head unit is fully seated, press down the
blue print head release lever until it clicks into place.
Caution:
c
Make sure that the Error and Pause lights are not
flashing. If they flash, you must remove the print head unit
(beginning at step 4) and reinsert it.
9. Open the ink cartridge clamp and remove the protective
paper sheet.
10.Lower the black ink cartridge into the print head unit with
the label facing up and the arrow on the top of the
cartridge pointing toward the back of the printer.
11.Press down the ink cartridge clamp until it locks in place.
You will feel some resistance.
8/1/95
EPSON Stylus COLOR IIs
ink
cartridge
clamp
EPSON Stylus COLOR IIs-9
paper
sheet