Loading Plain Paper - Epson Stylus Color Stylus Color IIs User Manual

4. Type the drive and directory name where the utility is
located. For example, type A:CALIBRAT (or
C:\ directory \CALIBRAT if it is on your hard disk). Then
press Enter.
5. When you see the Calibration Utility screen, make sure
Stylus COLOR IIs is selected as the printer. If it isn't, use
or to select it.
Also make sure Print Calibration Pattern is selected at the
bottom of the screen. (Use the Tab key to move down and
to select it, if necessary.)
6. Press Enter to select Calibrate. The printer starts the
calibration process.
7. The next screen prompts you to enter an offset value to
align the print head.
Wait for 1 minute while the printer prints a page of multiple
patterns of vertical lines, each of which is assigned an
offset value. In most patterns, the vertical lines are slightly
misaligned. Look for the pattern that is most closely
aligned.
|
|
Aligned Not aligned
8. Enter the offset value of the pattern that is most closely
aligned and press Enter. The printer prints another sheet
to verify that the alignment is correct.
9. If the vertical lines on the sheet are aligned, press Enter to
select Done. If the lines are not aligned, press Tab to
move to Re-calibrate; then press Enter to repeat the
calibration.
If you notice later that the vertical alignment of your printed
pages is off, repeat the calibration procedure.

Loading Plain Paper

This section explains how to load plain bond paper in the
printer. For instructions on loading coated or glossy paper,
envelopes, and transparencies, or on feeding paper one sheet
at a time, see the later appropriate section.
You can load up to 100 sheets of plain paper in the sheet
feeder. Be sure to load it with the printable surface facing up.
The printable surface is marked with an arrow on most plain
paper packaging.
Ink Jet Printers
|
|
1. Slide out the output tray located at the bottom of the
printer; then pull out the extension.
output tray
2. Slide the left edge guide on the sheet feeder to the left as far
as it will go.
3. Fan a stack of paper; then tap it on a flat surface to even the
edges.
4. Load the stack of paper, printable side up, so that its right
edge rests against the right side of the sheet feeder.
8/1/95
EPSON Stylus COLOR IIs
extension
EPSON Stylus COLOR IIs-11